Fetching the paper…
Reading the bibliography…
The gas-flow reduction factor of the second forward Differential Pumping Section (DPS2-F) for the KATRIN experiment was determined using a dedicated vacuum-measurement setup and by detailed molecular-flow simulation of the DPS2-F beam tube and of the measurement apparatus.
J. Bonn, B. Bornschein, L. Bornschein, M. Glugla, and O. Kazachenko, Tritium related parts of KATRIN: basic concepts and key requirements , Tech. Rep. 10-ME0100-00 (KATRIN Collaboration, 2003)
2003
Earlier work this paper cites.
G. Drexlin, Nuclear Physics B - Proceedings Supplements 145
2004
Earlier work this paper cites.
X. Luo, C. Day, V. Hauer, O. Malyshev, R. Reid, and F. Sharipov, Vacuum 80
2006
Earlier work this paper cites.
O. B. Malyshev, Vacuum 81
2007
Earlier work this paper cites.
J. Bonn, AIP Conf. Proc. 972
2008
Earlier work this paper cites.
X. Luo and C. Day, Journal of Vacuum Science and Technology A: Vacuum, Surfaces, and Films 26
2008
Cited alongside, same era.
O. B. Malyshev and K. J. Middleman, Journal of Vacuum Science and Technology A: Vacuum, Surfaces, and Films 26
2008
Cited alongside, same era.
O. B. Malyshev, Chr. Day, X. Luo, and F. Sharipov, Journal of Vacuum Science and Technology 27
2009
Cited alongside, same era.
R. Kersevan and J.-L. Pons, Journal of Vacuum Science and Technology 27
2009
Cited alongside, same era.
Specifically in the case of TMP, the common term in vacuum technology is the “Ho-factor”. For the sake of uniformity, in this work the term “capture factor” is used in all cases, regardless whether the boundary surface is defined at the inlet of a TMP or at some other boundary between subsystems, because all surfaces where capture factors are defined are treated in an equivalent way in the simulations presented here
Cited in the paper.
The necessary gas flow in this part of the measurement was higher than reachable by the installed gas-flow controller, and was therefore injected via a manual leak valve present in the system
Cited in the paper.
One should note that the necessary simplifications in the simulated geometry cause an in principle unknown systematic uncertainty in this value. We assume this uncertainty to be comparable or smaller than the uncertainty resulting from the uncertainty in pressure measurement
Cited in the paper.
Note that the flow rates for the noble gases are obtained by applying appropriate correction factors, due to the different sensitivity of the thermal-transfer method of mass-flow measurement
Cited in the paper.
2009
Later among the works it cites.
S. Reimer, Ein elektrostatisches Dipolsystem zur Eliminierung von Ionen in der DPS2-F des KATRIN Experimentes , Diploma thesis, Karlsruher Institute of Technology (2009)
2009
Later among the works it cites.
A. Windberger, Berechnungen und Simulationen zum Verhalten von Ionen in der differenziellen Pumpstrecke des KATRIN-Experiments , Diploma thesis, Karlsruher Institute of Technology (2011)
2011
Closest in time.
(2011), freeCAD open-source CAD software, http://sourceforge.net/projects/free-cad/
2011
Closest in time.
alphaXiv searches the wider corpus for related work and actual follow-ups.
alphaXiv is searching for related work…